If you’re facing a wobbly or leaky toilet, one common culprit could be loose or corroded toilet tank bolts. Don’t worry; removing and replacing them is a DIY task that can save you time and money. In this guide, we’ll show you how to remove toilet tank bolts in a few easy steps.
Before we dive into the removal process, gather the following tools and materials:
Safety First: Always turn off the water supply to the toilet before starting any work. You can usually find the shut-off valve located on the wall behind or near the toilet. Turn it clockwise to stop the water flow.
Flush the toilet to empty the tank. This will make it easier to work on the bolts without water interference.
Locate the water supply line connecting the tank to the wall. Use your adjustable wrench or pliers to loosen and disconnect it.
Carefully lift off the tank lid and set it aside. Be cautious, as some tank lids can be heavy and fragile.
Look inside the tank to locate the bolts securing it to the bowl. You’ll usually find two or three bolts. They are typically attached to a large nut on the inside.
Using your adjustable wrench or pliers, start by loosening the nuts and securing the bolts. If they are rusted or too tight, a lubricating spray can help. Once loose, continue to unscrew them until you can lift the tank from the bowl.
Lift the tank gently from the bowl and set it down on a soft surface, such as a towel or old blanket, to prevent damage. You may need an extra hand for this step, especially if the tank is heavy.
Take out the old bolts and gaskets from the holes in the bottom of the tank. If they are rusty or damaged, this is the perfect time to replace them with new ones.
If you’re replacing the old bolts, insert the new ones through the holes in the tank. Ensure they fit snugly and place the new gaskets over the bolts to create a watertight seal.
With the new bolts and gaskets in place, carefully position the tank back onto the bowl. Align the holes in the tank with the holes in the bowl.
Using your adjustable wrench or pliers, reattach the nuts to the bolts inside the tank. Be cautious not to overtighten them, as this could damage the tank or gaskets.
Reconnect the water supply line to the tank and tighten it securely.
Finally, turn the water supply valve back on and allow the tank to fill. Check for any leaks around the bolts and gaskets. If you notice any leaks, tighten the nuts slightly until the leaks stop.
Congratulations! You’ve successfully removed and replaced your toilet tank bolts, which should help stop any leaks or wobbling issues. This DIY task can be done with some patience and basic tools, saving you the hassle of calling a plumber.
Remember to take your time and follow the steps carefully. If you encounter any difficulties or the bolts are severely corroded, it may be wise to consult a professional plumber for assistance.
Running a plumbing business is hard work. You're juggling schedules, managing staff, handling emergencies, and…
When you’re on the job, you know that the fixtures you install reflect directly on…
Your clients trust you to protect their homes from a wide range of potential disasters,…
You know the drill. It’s 2:00 AM on a Sunday, and your phone rings. A…
If you’ve been in the plumbing game for any length of time, you’ve definitely come…
As a professional plumber, your success depends on having the right parts at the right…